My eagleware simulation(Linear and EM) and the physical hardware are nowhere close.
However if I simulate the exact circuit in AWR/Microwave Office I get results which look like my network analyser output, bad.
So, what is wrong with the setup of this eagleware simulation? Attached.
[file]blc_cband_orig.wsp[/file]
However if I simulate the exact circuit in AWR/Microwave Office I get results which look like my network analyser output, bad.
So, what is wrong with the setup of this eagleware simulation? Attached.
[file]blc_cband_orig.wsp[/file]
It would also help to know what you measured.