Hi All,
I am developing a lumped element filter (wsp attached) and am trying to determine how to do an empower simulation the board taking into account the pads of the mcx connectors.
Currently I have changed the box size to cover the middle conductor of the mcx connectors - but I am not satisfied with this approach since it leaves out a fair amount of copper area (read: capacitance).
Note: I haven't tuned the components selection yet ...
Any thoughts on how to proceed.
Regards,
Andrew
[file]nrc-xxx filter 400.16mhz 3 order rev a--scratch2.wsp[/file]
I am developing a lumped element filter (wsp attached) and am trying to determine how to do an empower simulation the board taking into account the pads of the mcx connectors.
Currently I have changed the box size to cover the middle conductor of the mcx connectors - but I am not satisfied with this approach since it leaves out a fair amount of copper area (read: capacitance).
Note: I haven't tuned the components selection yet ...
Any thoughts on how to proceed.
Regards,
Andrew
[file]nrc-xxx filter 400.16mhz 3 order rev a--scratch2.wsp[/file]