to create and rate content, and to follow, bookmark, and share content with other members.
accuracy in HARBEC simulation
Question asked by
on Jul 15, 2003
on Jul 17, 2003 by ROB_LEFEBVRE
Show 0 Likes
When I hit the calculator button to re-trigger the simulation in HARBEC, sometimes the plot comes up with the notice "Less Accuracy." Why is this, and how can I improve the accuracy?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Jul 17, 2003 4:51 AM
This message (also "Partial Convergence") means that the answer Harbec is providing did not converge to within the AbsTol/RelTol parameters specified, but that the answer appears to be within acceptable accuracy limits as determined heuristically by Harbec. If this is a high power device, you may want to turn down the Tol parameters by an order of magnitude or two.
If you are running Version 2003.03 and have not downloaded SP3, I strongly recommend it, as SP2 & 3 primarily have HARBEC fixes.
Show 0 Likes
Retrieving data ...
Linear Simulation Vs. Spice Models & S-para. Files
[PDF] ADS_SI_Q&A_018 What is broadband SPICE model and how to generate it?
How to create and use a link to SPICE file
Is there any B1500 GPIB command to record the voltage applied by a SMU at its Force terminal?
PNA-X B series Phase Ref Cal issue