Skip navigation
Register
Home
Forums
Blogs
Help
My Links
My Bookmarks
My Questions
My Places
Log in
0
Search
Search
Search
Cancel
Error: You don't have JavaScript enabled. This tool uses JavaScript and much of it will not work correctly without it enabled. Please turn JavaScript back on and reload this page.
All Places
>
Discussion Forums
>
EDA Software
>
Questions
Log in
to create and rate content, and to follow, bookmark, and share content with other members.
Answered
Assumed Answered
Differential Port available in EMPro 2011.02?
Question asked by
wangyiliu99
on Mar 2, 2011
Latest reply
on Mar 3, 2011 by wangyiliu99
Like
•
Show 0 Likes
0
Comment
•
2
A quick question, is it possible to set the differential port as in the lastest release EMPro 2011.02, like in HFSS?
Thanks a lot!!
Outcomes
This content has been marked as final.
Show 2 comments
2 Replies
Name
Email Address
Website Address
Name
(Required)
Email Address
(Required, will not be published)
Website Address
HSLEE
Mar 2, 2011 10:47 PM
Mark Correct
Correct Answer
Unfortunately not. What type of structures do you want to simulate?
wangyiliu99
Sep 24, 2013 3:15 AM
Mark Correct
Correct Answer
Since differential port is not supported in current version,
does this mean that the line feed source start point is connected to the GND by default?
(with the end point having the arrow in the geometry being the hot)
does this mean that the line feed source start point is connected to the GND by default?
(with the end point having the arrow in the geometry being the hot)