to create and rate content, and to follow, bookmark, and share content with other members.
About the ground connection in momentum
Question asked by
on Dec 19, 2006
on Dec 20, 2006 by ALEPEREZ
Show 0 Likes
Hello, I am simulation one patch antenna by momentum. I want to add one more patch in which one brim is connected to the ground. How can I do this in momentum?
Any suggestion is welcome. Thanks.
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Dec 20, 2006 2:42 AM
I'd suggest taking a look at the Momentum examples in ADS in the Antenna subfolder. If that doesn't help, just send the specifics to Agilent tech support and they should be able to set up a simple example for you fairly quickly. It sounds like you can use a sheet via to connect the patch edge to the ground (like the F antennas that have a strap going around the edge of a substrate).
Show 0 Likes
Retrieving data ...
Thinking how to get money off Cash App without card and without net? Call customer care.
how to simulate the large siganl loop gain
Contact Facebook if you have problem getting a code for account activation?
Power calibration with use of receiver "A"
Importing EMPro circuit component definition from ADS