AnsweredAssumed Answered

some problems about via

Question asked by cqcq on Oct 3, 2008
Latest reply on Oct 7, 2008 by ALEPEREZ

Like • Show 0 Likes0
Comment • 2

Hi! I have some problems about via.
1.why I cannot see via hole in 3D preview after I changed the "cond" model from sheet to Thick?
2.How can I makesure a via has been correct connect "cond" layer to ////GND/////?
3.Can I see ////GND//// layer? or delete it?

-cqcq

substrate setting as follow:
/////GND///////////
Air
---------STRIP-cond
Msub1_1 |VIA| hole
/////GND///////////

No one else has this question

Outcomes

cqcq Oct 3, 2008 7:25 PM

Sheet

Thick

Substrate setting

Actions

ALEPEREZ

Oct 7, 2008 5:36 AM

The infinite ground planes cannot be displayed. Once you make a layer 3D thick, when it is shaded, the vias below will not be visible unless you rotate the structure to the right angle. If you are seeing some other problem, please send the file to the EEsof support department to look at it for you.

Actions

2 Replies

cqcq Oct 3, 2008 7:25 PM
Mark Correct
Correct Answer
Sheet

Thick

Substrate setting
Like • Show 0 Likes0
Actions
ALEPEREZ Oct 7, 2008 5:36 AM
Mark Correct
Correct Answer
The infinite ground planes cannot be displayed. Once you make a layer 3D thick, when it is shaded, the vias below will not be visible unless you rotate the structure to the right angle. If you are seeing some other problem, please send the file to the EEsof support department to look at it for you.
Like • Show 0 Likes0
Actions

some problems about via

Outcomes

Related Content

Recommended Content