If components are laid out on a (say) 0.125 grid and later the grid is changed to (say) 0.1 then the components/wiring won't align - fair enough.
However, if you then move the components on the new 0.1 grid they still don't snap to the grid points correctly. Only cut/paste will place them on the grid. Are there any workarounds? Could this be fixed in a new release (or at least a "align to new grid" button)
Laurens
However, if you then move the components on the new 0.1 grid they still don't snap to the grid points correctly. Only cut/paste will place them on the grid. Are there any workarounds? Could this be fixed in a new release (or at least a "align to new grid" button)
Laurens
-Mats