AnsweredAssumed Answered

F_Uniform_delta

Question asked by PAULOAU on Jul 19, 2004
Latest reply on Jul 21, 2004 by PAULOAU

Like • Show 0 Likes0
Comment • 2

I'm trying to simulate a design in ADS2003C that I created in ADS2002C. ADS returns the following error message:
"Error detected by HPEESOFSIM during netlist parsing. Redefinition of 'F_Uniform_delta'."
Does anybody have a clue of what that means and how could I solve it.
If I create the design all over again using ADS2003C version, the error message does not appear. But, besides being tedious to do this, it is very easy to make mistakes with circuits with lots of components.
Thanks in advance. Paulo

No one else has this question

Outcomes

2 Replies

mfredrik Jul 20, 2004 7:05 AM
Mark Correct
Correct Answer
I did some research about the error message that you are seeing. Could not find any reports about this.

Please send a sample design which shows the problem to EEsof Technical Support:
- By email
- Directly from Knowledge Center
Like • Show 0 Likes0
Actions
PAULOAU Jul 21, 2004 2:34 AM
Mark Correct
Correct Answer
I found out what the problem was. It was caused by a component used by the Design Kit that I'm using. In this component, a variable named "F_Uniform_delta" was set twice. So, the "redifinition of F_Uniform_delta" occurred. If I erase this component in the design that was created with the 2002C version and reinsert it again with the 2003C version, the problem is solved (when I do this the variable is set just once, I don't know why). That's the reason why when I created the design all over again using ADS2003C version the problem was also solved.
Thanks anyway.
Like • Show 0 Likes0
Actions

F_Uniform_delta

Outcomes

Related Content

Recommended Content