AnsweredAssumed Answered

MixerRF problem in Ptolemy simulation.

Question asked by 0133songbo on Jan 22, 2005
Latest reply on Jan 31, 2005 by JWOJTIUK

Like • Show 0 Likes0
Comment • 2

I found a problem in MixerRF. When LO is high injected and the type of MixerRF is set as 'LO minus
RF', the BER simulation always get wrong results.While when Lo is low injected and type of MixerRF is set as 'RF minus LO', the BER results are right. I found this problem in many examples.

No one else has this question

Outcomes

2 Replies

bafisher Jan 24, 2005 11:26 AM
Mark Correct
Correct Answer
This problem should be reported to our Technical Support department. If you are a supported customer, please contact the Technical Support department in your region:

http://eesof.tm.agilent.com/support/
Like • Show 0 Likes0
Actions
JWOJTIUK Jan 31, 2005 8:55 PM
Mark Correct
Correct Answer
Isn't your spectrum inverted when you do that???
Like • Show 0 Likes0
Actions

MixerRF problem in Ptolemy simulation.

Outcomes

Related Content

Recommended Content