to create and rate content, and to follow, bookmark, and share content with other members.
How to simulate differential devices in Genesys?
Question asked by
on Oct 24, 2007
on Oct 29, 2007 by JERRY_MARKETOS
Show 0 Likes
How do I simulate balanced devices with Genesys using a four port Touchstone file?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Oct 29, 2007 2:55 AM
Assuming the 4-port datafile represents a 2-port device measured differentially, use a 4-port datafile block to link to the datafile. Then use the ideal transformer model to connect to the datafile. One winding of the transformer connects to the differential datafile ports. Other winding of the transformer gets an input port and ground (or output port and ground etc.) Note the input and output ports for linear simulation are no different- they're just reference port numbers for linear analysis. Only difference is the appearance of the schematic symbol.
Show 0 Likes
Retrieving data ...
vrf User Changeable parameters
how to simulate the large siganl loop gain
Executing and sending commands to console program
U1733C LCR Meter flashing error
Calibration of path involving 50 db attenuator through PNA 5242A.