Forum:
I'm a little confused about stripline bend modeling. I understand that my current SBN model supports only a "full-cornered" bend-- a square corner for a 90 degree bend. This gets ugly when designing for low VSWR.
Does Eagleware currently support mitered bends for stripline media?
If not, do they plan to offer these in the future?
Thanks.
Regards,
Geoff Kline
VertexRSI
I'm a little confused about stripline bend modeling. I understand that my current SBN model supports only a "full-cornered" bend-- a square corner for a 90 degree bend. This gets ugly when designing for low VSWR.
Does Eagleware currently support mitered bends for stripline media?
If not, do they plan to offer these in the future?
Thanks.
Regards,
Geoff Kline
VertexRSI