to create and rate content, and to follow, bookmark, and share content with other members.
Changing the Default QL in Genysys 7.52
Question asked by
on Apr 27, 2005
on Apr 27, 2005 by JERRY_MARKETOS
Show 0 Likes
How do I change the Default QL to a more realistic value for all Inductors and capacitors instead of having to change the Qs by clicking on the properties of every single Q in every single inductor and capacitor of my schematic?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Apr 27, 2005 8:40 AM
Back in version 7.52, the default Q was set internally to
very high value consistent with ideal models. In a later
version the ability was added for users to set the initial
default Q as you request. Thus the solution is to update
to current version software and the ability to set the global
default values for ind & cap Q will be among the many
improvements you get. Q can still be set independently
for each component in the modern version software, as well.
Show 0 Likes
Retrieving data ...
Measuring Thermal Noise of Amplifier
HP 8594A YTO readings
Noob Graphing Question
Square law detector on spectrasys
RF simulation: beginning !