Apparently Eagleware doesn't intend to add the choice between length of combline leads in mils (like in the past) in mfilter and combline leads in degrees.
So, isn't it possible to add in TLINE, for microstrip type, computations of length=f(Ldeg,K,Vp,F), Ldeg=f(length,vp, f,K) and Td=f(length,vp,K) according to formulas described in synthesis manual page 406 ?
This should avoid to take the synthesis book p406 and computer at each new design.
Marc
So, isn't it possible to add in TLINE, for microstrip type, computations of length=f(Ldeg,K,Vp,F), Ldeg=f(length,vp, f,K) and Td=f(length,vp,K) according to formulas described in synthesis manual page 406 ?
This should avoid to take the synthesis book p406 and computer at each new design.
Marc