Hello,
On page 96 of your Agilent 3000 Series Osci User's Guide it is mentioned the following automatic time measurements, besides other:
Delay 1- 2, rising edges, Delay 1- 2, falling edges, ...
I cannot find this in the Agilent 3000 Series Programmer's Reference Manual.
How I can access this Delay measurement or programm it, what is the GPIB command ?
Thanks
Markus
On page 96 of your Agilent 3000 Series Osci User's Guide it is mentioned the following automatic time measurements, besides other:
Delay 1- 2, rising edges, Delay 1- 2, falling edges, ...
I cannot find this in the Agilent 3000 Series Programmer's Reference Manual.
How I can access this Delay measurement or programm it, what is the GPIB command ?
Thanks
Markus
implemented in the Remote commands.