to create and rate content, and to follow, bookmark, and share content with other members.
Multilayer Step Component
Question asked by
on Aug 31, 2004
on Aug 31, 2004 by mfredrik
Show 0 Likes
Is there a component for a multilayer tline step? I am changing linewidths frequently in my schematic, but cannot find the proper Step component to use.
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Aug 31, 2004 3:34 AM
You seem to be correct in your findings. Can't find any step model for the multi-layer library.
I have submitted an enhancement request for that, Simulation.10397.
Create your own step model using Model Composer:
Open a layout window
Setup your substrate in
Momentum > Substrate > Create Modify
(See Momentum manual for more info)
Save the substrate
Momentum > Substrate > Save As
Open a schematic window
Start Model Composer,
Tools > Model Composer > Create/Modify Library
Enter the name of your "library" on the first screen
On the second screen, browse and locate your Momentum substrate that you saved earlier
Set frequency and line width limits on the third page
Select the "step" model in the list of components on the fourth page
Names/prefixes on page 5
Setup the ranges for W1 and W2 on page 6. Be conservative since the wider ranges you specify yields in longer simulation times. If possible, use discrete list of values instead of a continous range to speed up the simulations. Start with something small and see how long time the simulations take and then increase the complexity.
Save the library and then start the model generation
Show 0 Likes
Retrieving data ...
In ADS 2015, how to define ports as internal or external while working in layout design of circuit.
ports numbers used by Agilent PC Software
Problem with allegro PCB extraction in ADS
[PDF] ADS_SI_Q&A_021 How to Import a PCB layout into ADS layout editor?
[PDF] ADS Design Flow Integration - ADFI