AnsweredAssumed Answered

Defining a user defined calibration kit by software

Question asked by krustykanuck on Mar 26, 2009
Hello,

I am looking to define a MCX test kit on an Agilent 8753ES for one-port calibration using a program. However this kit utilizes two short standards (one with an offset - typical for waveguides) intead of an open.  I haven't seen any examples on defining a second short standard where one is defined to CLASS11A and the other CLASS11B.  I am unsure of the sequence of commands for this and I have tried some SCPI commands only to wind up with an error or two.  Are there any examples of this or procedures that must be followed with the definition?  I have all of the offset parameters needed, it is just a matter of properly defining them on the Network Analyzer before running the program.

Thanks..  

Outcomes