AnsweredAssumed Answered

Labview control Program for VNA N5230A

Question asked by Simarjit on Jun 18, 2008
Latest reply on Jun 22, 2008 by odanzy
Hi,

As I need to take a lot of measurements.
I need to write a program to interface the VNA N5230A(10MHz - 20GHz)with a PC(Windows xp) using LAN in LABVIEW 8.5.
As I can think of it should have a automatic filename gen(pos n orientation of tx n rx). The control part should have various parameters (start/stop freq, no of measurements pts, s parameter, If BW).
The control prog O/P a text file that contains the measurement data of 1 VNA sweep!
Can anyone guide me here! 

Thanks,
SAM  

Outcomes