AnsweredAssumed Answered

Cal Factor Table

Question asked by htnicolas on Sep 1, 2011
Latest reply on Sep 2, 2011 by Dr_joel
Hi,

I would like to easily create/edit cal factor tables on my E4419B Power Meter, so that these tables can be loaded
during a Guided Power Calibration on a E8364C PNA.

I found in the Programming guide of the Power Meter the following commands, under the MEMory:TABLe:Node:
"
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
MEMory:TABLe:FREQuency:POINts?
MEMory:TABLe:GAIN[:MAGNitude] <numeric_value>{,<numeric_value>}
MEMory:TABLe:GAIN[:MAGNitude]:POINts?
MEMory:TABLe:MOVE <string>,<string>
MEMory:TABLe:SELect <string>
"

...which makes absolutely no sense to me. Can somebody show me an example of these commands or how to use them?
And confirm that this would indeed create a cal factor table?

Also - assuming I have the table created and stored on the Power Meter - I think I would use SOURce<cnum>:POWer:CORRection:COLLect:TABLe[:SELect] ASENsor
to load the table from the PNA.
But how do I specify the correct table? There can be up to 20 tables stored on the Power Meter...

Thanks,  

Outcomes