to create and rate content, and to follow, bookmark, and share content with other members.
want the labview driver of N5230A PNA-L for WinXP
Question asked by
on Apr 18, 2006
on Apr 19, 2006 by odanzy
Show 0 Likes
Who can help me the labview driver of PNA N5230A(300K to 6G) for WinXP .
I can not find the match driver version for PNA N5230A all over the internet.
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Apr 19, 2006 6:16 AM
I will start by saying I typically recommend shying away from drivers as they can hinder the performance of the program. For the PNA we recommend using the PNA's COM interface or Direct I/O with SCPI commands. Also, the programming commands for both the PNA and PNA-L are the same. This means that most programs and drivers that will work for the PNA will also work for the PNA-L, unless they are IDN string blocked. This being said, there are two driver options that I have used.
1) There is an IVI COM driver near the bottom of the PNA programming website. This driver supports both the PNA and ENA. This driver will work in languages other than LabView (e.g. VEE, VB, C++). This is nice because if you use the Agilent Specific Class the program will execute on either the PNA/-L or ENA.
PNA Programming Website:
2) There is a pretty good LabView certified driver, "agpna", on the National Instruments' Instrument Driver Network website that supports the other PNA models (e.g. E8364B) that will also work with the PNA-L.
Show 0 Likes
Retrieving data ...
is there an API for USB and LAN sensors?
34410A trigger behaviour in Average mode
Typo report in Programmer's Guide for Infiniium Oscilloscopes (PDF)
Default mesh settings
Plugged via support in EM setup