AnsweredAssumed Answered

linear phase with open and short loads.

Question asked by mozen on Dec 17, 2006
Latest reply on Dec 18, 2006 by odanzy
Hi, I have ques. about calibration;

I am using 85056D economy calibration set, but when measuring short or open response I got linear phase varying between minus pi and pi. Magnitude responses was flat and zero dB.

I adjusted  port extensions to obtain a flat phase response with open load, and I obtained almost flat phase response. Then I measured short response, it was almost flat,

I measured both short and open responses with same calibration plane, I did not use any adaptor. Finally with port extension phase is flat, But  I still am wondering that this calibration is correct?

Thanks.

Mustafa OZEN

__________________________________________________  

Outcomes