AnsweredAssumed Answered

4395A Raw Data Arrays

Question asked by aether on Nov 25, 2010
Latest reply on Nov 28, 2010 by Dr_joel
I am using a 4395A with calibration set to 'None' and would like to read the raw data arrays (mag and phase) for R, A, and B ports. I am currently doing three sweeps and changing the measurement mode to the next port after a sweep ("MEAS R") and reading "OUTPRAW1?".

Is there a way to measure raw arrays for R, A, and B after only one sweep with no calibration?

Thanks  

Outcomes