AnsweredAssumed Answered

Port reordering in PLTS

Question asked by cram869 on Jun 21, 2011
Latest reply on Jun 21, 2011 by ningchen
Since upgrading to PLTS 2011, I haven't been able to reorder my ports in the DUT Configuration window.  Each time I try, I have been getting this error message, and the ports are reset to their default configuration.

"Cannot switch PNA ports or DUT ports if test set is not available"

I'm not really sure what test set the message pertains to.  Any help would be appreciated.  I typically have to chose my port configurations based on which cable is most easily contorted to match my probe connections on the boards.

FYI: The PNA is an N5242A with the A.09.22.02 firmware.

Thanks,
Michael  

Outcomes