to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Mar 25, 2006
on Mar 25, 2006 by Dr_joel
Show 0 Likes
I wonder what kind of network analyzer is fit for GPR design. The operating frequency is between 10MHz and 6GHz.
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Mar 25, 2006 9:44 PM
Hi, I'm not sure what you mean by GPR, but I'm going to guess "Ground Penetrating Radar"
There are two obvious choices:
1) ENA - most economical, has an 300kHz to 8.5 GHz response, in 2-4 port models. It has a very simple user interface, and it is used widely in manufacturing environments.
2) PNA-L; this has a 300kHz-6GHz model. The PNA-L has very similar features to the ENA, but it comes with a configurable test set option which allows you to re-wire the directional couplers, sources and receivers. For R&D, this can be very useful, especially in an application with higher powers.
Tell us a little more about what you're trying to measure.
Show 0 Likes
Retrieving data ...
On a E4438C when using a PRAM file for data I was able to add a data bit with non burst too turn off the carrier. I can not seem to do this with the N5182B using the same PRAM file. How do I turn off the RF?
can't communicate to 34405A with Keysight Connection Expert
New vs. Old IO Libraries Questions.
Query regarding E4406A VSA Transmitter Tester, 7 MHz to 4 GHz