AnsweredAssumed Answered

FCA (SMC) Swept Power Measurement (CW Freq)

Question asked by bwillis88 on Dec 11, 2007
Latest reply on Dec 12, 2007 by bwillis88
I am successfully performing typical swept RF/swept LO SMC measurements.  However, I'd also like to get some swept power compression curves at a couple discrete singles frequencies.  This is a downconvertring mixer.

Can I do this with the FCA?  My thinking is to use FCA by equating the start and stop RF frequencies, entering fixed LO, which will give a single frequency IF.  However, it only gives me one power level for the RF to cal at.

thanks,
Bill  

Outcomes