AnsweredAssumed Answered

How to know if PNA Source Cal failed?

Question asked by matti on Aug 21, 2006
Latest reply on Nov 19, 2007 by nickmmw
I'm using E8364B, I do Source Cal done with command
"SOUR:POW:CORR:COLL ASEN"
Normally that works ok, but if and
when the source cal fails (red block letters FAIL)
I would like know that programmaticaly, but I cant find out how.
I tried SYST:ERR:COUNT? but it returns happily "+0 "No error"

Any suggestions so I don't have to ask the user if the Source Cal
succeeded?
Maybe I should check if the Source Cal Correction was turned on afterwards? But how?


Sincerely
Matti Hjelm  

Outcomes