to create and rate content, and to follow, bookmark, and share content with other members.
85071E-100/-200/-300 on E5071C
Question asked by
on Feb 17, 2011
on Feb 18, 2011 by andyowen
Show 0 Likes
hi, can anyone advise on how to run the 85071E-100 or -200 or -300 on the E5071C? I read from the database that E80571E-100 or -200 can only be used on PNA. Is there any way to use it on a E5071C?
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Feb 18, 2011 9:12 AM
Both the 85070E and 85071E material measurement software products can run on the ENA series analyzers. Please refer to the following FAQ entry and related link for the details:
http://www.home.agilent.com/agilent/edi ... id=1330022
http://www.home.agilent.com/upload/cmc_ ... E5071C.pdf
Can you post the link to the "database" that did not list the E5071C as supported hardware? It may need to be updated.
Show 0 Likes
Retrieving data ...
AgilentLXIWebservice Error on 34465a DMM
Crashing ADS 2011.10 leads to 'locked' schematics/layout files
what determines the longest group delay a vna can measure?
synchronization between the waveform transmission and data capturing
TS-5400 System Software v6.0 Service Pack 1