I have a Agilent Technologies power supply N6700B used in automated testing. I would like to know if there's a way to set multiples channels to different voltages at the same time. I know the command to set multiple channels to the same voltage at the same time, VOLT 10, (@1,2) sets channel 1 and 2 to 10 volts at the same time. My requirement is to set channel 1 to 1.0 volt and channel 2 to 3.3 volts at the same time. The closest way of achieving this currently is to run commands one right after another but just wondering if there's a single command that would accomplish the same task. Thanks.