Now I am create a command sequence on N9030A, when I add command for Reference Level Offset on the sequence, the command is not running but other command running, Do I need delay on my sequence ?
Can you help me ?
Changing the offset will cause the analyzer to stop a current sweep and prepare for a new one.
However, I am not sure under what condition changing the Reference Level Offset would not run in a sequence. Other than testing that the Reference Level Offset is working on its own, I would try placing this command at the beginning of your sequence if possible.
Can you show me the sequence of commands so that I can test them?
I'll look into your question and let you know what I find out.
Thankyou for your help and reference link about my question. I will try place offset command on my command sequence, my sequence just doing auto tune and read the x value and y value, so I need to add reference level offset to get the real value rom my DUT.
Thankyou very much.
Retrieving data ...