AnsweredAssumed Answered

How can I activate the serial bus decoding (as the softkey does) using LabVIEW?

Question asked by ism.dob on Feb 26, 2018
Latest reply on Feb 27, 2018 by ism.dob



I have been playing around with the LabVIEW drivers to try to log the information coming from a SENT bus signal. I have not found any examples for this functionality.


The main problem is that I am not able to activate the serial bus decoding. I can configure it and that's all. I would like to grasp the information out of the lister, but I do not know if this is possible.


Thanks in advance and kind regards,