When I send GPIB commands OUTPUT:SYNC ON or OUTPUT:SYNC OFF, the output (50 Hz sine wave) glitches and jumps phase.
Is this normal and expected ?
I am switching Sync on and off to trigger DVMs in a controlled way at a rate of about 1/s
When I send GPIB commands OUTPUT:SYNC ON or OUTPUT:SYNC OFF, the output (50 Hz sine wave) glitches and jumps phase.
Is this normal and expected ?
I am switching Sync on and off to trigger DVMs in a controlled way at a rate of about 1/s
Hi,
I have the same behavior with my 33120a.
Regards
Yves