AnsweredAssumed Answered

Identify SCPI command for front panel setting

Question asked by PhilAtkin on May 11, 2017
Latest reply on May 11, 2017 by PhilAtkin

I'm a software engineer.  Assume I know nothing about PNAs - that's not far wrong.  My customer wants me to program her PNA's parameters and make measurements.  I've achieved this to some level but here's the problem: when she describes a parameter she wants to set, she uses terms that I can't match to the SCPI command descriptions.

 

What I would like is for her to make a front-panel adjustment of the parameter, then to see the SCPI commands that correspond to the setting.  That way, the correspondence between the setting she makes and the command I need to send is established unambiguously.

 

Is there a way to do this?  Thanks in advance, Phil

Outcomes