AnsweredAssumed Answered

Don't know how to conduct this four probe test

Question asked by edisn on Nov 10, 2008
Dear friends,

I am not sure if I have published this in the right place.

I got stucked in the experiments, not sure how to test the device using the available equipments in the lab: Micromanipulator Model-- 8060-US8-V0-1-A; Agilent Technologies Model: 4155C and 4284A.

There are four contacts pads in the device. No. 1 and 2 are connected by a suspended straight wire, No. 3 and 4 on each side of the wire.
During test, the wire will be applied a DC. Pad No. 3 will be supplied with high frequency AC. The capacitance between No. 4 and the wire need to be tested.

Anyone can tell me how to configure this? Only one Agilent Model can be connected in ICS, is that right?
Thanks!

Ed  

Outcomes