Recently I use USB in the back panel to remote communication with DSO1052B. When the oscilloscope is still in "waiting" status and not triggered, at Single mode, I try to get the waveform data from the oscilloscope. The oscilloscope becomes dead once I sent the command to get waveform data. See the attached picture for details.
In this case, I need to reset the oscilloscope by power down and power up again.
Dose anyone find the same problem before? How to solve it?
In this case, I need to reset the oscilloscope by power down and power up again.
Dose anyone find the same problem before? How to solve it?
Al