AnsweredAssumed Answered

LNA output matching

Question asked by ata_sa2016 on Mar 4, 2016
Latest reply on Mar 23, 2016 by RFlyx

Hello guys,

I have been busy with a problem for couple of days. I will be more than grateful if you help me with this.

I am new in RF design and I am trying to simulate a simple LNA with ADS. My problem is, I do not want to match my LNA's output to 50ohm because, it is in the chip and it will be connected to mixer.

My question is, when I put terminal at the output of LNA what should be the Z of terminal. Without output terminal I am not able to observe noise and some other parameters. I can just plot S11  >:(

best,

Ata

Attachments

Outcomes