AnsweredAssumed Answered

Momentum/EMPro simulation stop and re-run

Question asked by teleko7 on Jun 2, 2015
Latest reply on Jun 11, 2015 by teleko7
Hi all

I've checked the EDA documentation site to look for this but this only partially answered my question.

This may look silly but If for some reason i needed to stop a long momentum simulation, wait for some time (or have a look at the results up to that point) and then re-run it from where I stopped it... is it possible?

I'm doing a PhD in MMICs, and my present simulations take days to complete, with many simulation points, so I would like to know if there were any means to "check" whether my already simulated points tell me if my design is good or bad, not to waste time, or to let the simulation complete...

And same for EMPro.

Regards

Iban  

Outcomes