I'm trying to measure the time response of a resistance change using a 34420A meter.
I've noticed that sending TRIG:DEL xx gives me insconsistent results.
I'm using a Labview program to time the execution of 1000 measurements, and then calculating the time/measurement.
If I set my delay to 283 msec, my calculated time/measurement is 291.873 msec.
But if I set the delay to 284 msec, the calculated time/measurement drops to 205.624 msec.
Has anyone run into this? Any suggestions or explanations?
I've noticed that sending TRIG:DEL xx gives me insconsistent results.
I'm using a Labview program to time the execution of 1000 measurements, and then calculating the time/measurement.
If I set my delay to 283 msec, my calculated time/measurement is 291.873 msec.
But if I set the delay to 284 msec, the calculated time/measurement drops to 205.624 msec.
Has anyone run into this? Any suggestions or explanations?