AnsweredAssumed Answered

Source Power Calibration Options

Question asked by crreed on Jul 15, 2013
Latest reply on Jul 23, 2013 by daras
Hi Everyone!

I have a PNA N5224A model and am having difficulty locating the commands to adjust the parameters found in the "Source Power Calibration Options" dialog box.

I will use the "Use a power meter once, then use the PNA reference receiver." within a "Cal All" Calibration.  From the front panel this setting appears to apply universally to any subsequent calibration, so I need to configure it via SCPI commands prior to initiating the "Cal All Channels" routine.

Specifically, I need to activate the "Use the power meter at" feature, and define it to either 0 dBm for the 8487A or -30 dBm for the 8487D power sensor.  What is the SCPI command to do this?

Thanks in advance.

Best regards,
Charles  

Attachments

Outcomes