AnsweredAssumed Answered

PNA-X: Error 612 after SMC+Phase calibration

Question asked by alhum on Jan 13, 2014
Latest reply on Jan 14, 2014 by johanericsson
Hello everyone,

I am trying to do an SMC+Phase calibration without success. I first run the phase reference wizard and save my calset. Then I run an SMC calibration setup wizard and enable phase measurement with "Use Phase Reference Calset". I recall my previously saved phase reference calset. Then, I follow the steps until the calibration is finished and the wizard proposes me to save the calset. When I do this, I get the following message on the screen: "Error 612: The Error Term data required for the selected caltype was not found." and the calset is not saved. I don't have this problem if I don't enable phase measurements.

Here are some information about my PNA-X:
Firmware Rev:       A.09.90.07
Model Number:       N5241A

What did I miss?

Thanks,

Alexis  

Outcomes