Power Meters and Sensors
to create and rate content, and to follow, bookmark, and share content with other members.
Measuring peak powers below 50MHz
Question asked by
on Jun 17, 2014
Show 0 Likes
I have a peak power analyzer, 8990B but all the peak power sensors from KeySight has a minimum RF frequency of 50MHz. I would like to measure as low as 10MHz. Could you help advise how I can do so?
No one else has this question
Mark as assumed answered
This content has been marked as final.
(Required, will not be published)
Retrieving data ...
[WMV] 介紹CMOS OP放大器的DC, AC及Transient模擬
Two Types of Antennas You Can Design With ADS
How to draw structure in in Momentum and EMpro by paramters
Antenna Design Using Fully Integrated 3D EM in ADS
Adding a Port to an Antenna and Moving one antenna relative to another