AnsweredAssumed Answered

Enabling and Disabling User Defined Buttons in New GUI

Question asked by dbailey on Dec 19, 2013
Latest reply on Apr 8, 2014 by dbailey

Like • Show 0 Likes0
Comment • 2

As in the online help files, I've assigned USER button 2 to execute a small program for adjusting fixture scanners. This works fine; however, is there some way to disable and enable this button the the same way the "Browser" button automatically enables and disables when the testplan is loading, etc.?

Thanks,
Dave

No one else has this question

Outcomes

2 Replies

leo_br Dec 24, 2013 7:41 AM
Mark Correct
Correct Answer
I do not understand your question. Would show the image with your problem?

Regards,
Leo
Like • Show 0 Likes0
Actions
- dbailey @ leo_br on Apr 8, 2014 5:51 AM
  Mark Correct
  Correct Answer
  Hi Leo,
  
  Are you familiar with the new GUI? When you log in as operator and the after the GUI launches, there are four software buttons in the lower left corner of the screen. One of them is assigned to launch the browser (and is labeled "Browser"). The other three buttons are labeled USER2, USER3 and USER4. I have modified USER2 to launch a barcode scanner utility, and it works.
  
  What I want to do is disable USER2 until the testplan is fully loaded. Right now, as the GUI is loading, and the testplan comes up, the scanner utility USER2 is available and can crash the testplan load (because the testplan load initializes the scanners).
  
  Attached is a blurry picture taken from a not smart phone. Does that help?
  
  Thanks,
  Dave
  Attachments
  - button.JPG21.5 KB
  Like • Show 0 Likes0
  Actions

Enabling and Disabling User Defined Buttons in New GUI

Outcomes

Attachments

Related Content

Recommended Content