AnsweredAssumed Answered

Can't recognize GPIB0, and error

Question asked by lcormier on Aug 20, 2013
Latest reply on Aug 21, 2013 by Dr_joel
I am attempting to use Maury ATS to do a load pull with x-parameters. My tuner is a GPIB tuner.  Agilent Connection Expert does not find the instuments connected to GPIB0 (the upper GPIB connector on the N5242 rear), but instead finds them connected to GPIB5. I have a generator(E4438C)
for the phase reference connected to GPIB0.
Also, Connection Expert recognizes that there is something on address 11( also incorrect on GPIB5), which is the tuner controller, but does not read the ID given by the controller, and errors out.  

Outcomes