AnsweredAssumed Answered

Sequences and offsets

Question asked by 3lionsct on Jan 8, 2014
Latest reply on Jan 8, 2014 by 3lionsct
Hi,

I am using a 33500B with BenchLink Waveform Builder Pro to do some sequence loading. I have created a single channel waveform which has two trapezoid pulses. One goes from 0 to 2v and back to 0. The other goes negative 0 to -1v and back to 0v. I sent it to the unit and it reports an offset of 500mV but it plays out as you would expect, the two pulses centered around 0v. However, now if I create a sequence which is just two of the same waveform and play it out, it sets the offset to -500mV  and that's how it plays out

I want to hook this generator up to some high powered amplifiers and an offset that high will blow up the load

Does anyone know what is going on with these offsets?

Thanks  

Outcomes