AnsweredAssumed Answered

PNAX Source Power Calibration connections

Question asked by lcormier on Dec 18, 2013
Latest reply on Dec 20, 2013 by johanericsson
If one tries to do a Source Power calibration, the comment in the dialog box is " Make all the connections to the DUT and the necessary components/instruments for your measurement setup, and click OK to continue...

If all the connections for the DUT are in place, where would a power meter go?  If I were to get past the next point without an error message, will it also measure the power for the output port tickler tone(s)?  

Outcomes