Dear All,
in the EMPro/ADS Documentation about Initial Mesh Options for FEM Simulations, there's the following phrase:
*The ratio between the Initial Target Mesh Size (A) and Initial Minimum Mesh Size (B) cannot be lower than 10 to provide the mesher enough freedom to fill the solution space with tetrahedra.*
Could you please clarify the meaning of it?
is it meant: A/B>0.1 or A/B<0.1?
Best regards,
Angelo
in the EMPro/ADS Documentation about Initial Mesh Options for FEM Simulations, there's the following phrase:
*The ratio between the Initial Target Mesh Size (A) and Initial Minimum Mesh Size (B) cannot be lower than 10 to provide the mesher enough freedom to fill the solution space with tetrahedra.*
Could you please clarify the meaning of it?
is it meant: A/B>0.1 or A/B<0.1?
Best regards,
Angelo