Sorry to post here, but I didn't see a good section to post in.
I would like to verify some handwritten notes in the Specification Table of my 3335A service manual. The 50 Ohm attenuator accuracy specs have been changed to the following:
0-38 +/- 0.025 dB
40-58 +/- 0.030 dB
60-98 +/- 0.090 dB
Can anyone verify this and if true, can Agilent (or anyone) perform the calibration of a 3335A to this spec?
Thanks,
Will
I would like to verify some handwritten notes in the Specification Table of my 3335A service manual. The 50 Ohm attenuator accuracy specs have been changed to the following:
0-38 +/- 0.025 dB
40-58 +/- 0.030 dB
60-98 +/- 0.090 dB
Can anyone verify this and if true, can Agilent (or anyone) perform the calibration of a 3335A to this spec?
Thanks,
Will