AnsweredAssumed Answered

see SCPI sent via the web interface

Question asked by mdewar on Nov 4, 2011
Latest reply on Nov 7, 2011 by mdewar

Like • Show 0 Likes0
Comment • 3

I am using the web interface for connection expert to configure an ESG Vector signal generator.
How to I see the SCPI commands sent when pressing the buttons on the Web-UI?

My goal is to use these commands for test automation.

Thanks,
m

No one else has this question

Outcomes

3 Replies

tabbott Nov 4, 2011 1:51 PM
Mark Correct
Correct Answer
Hi m -

1.)     Open the web interface for the ESG
2.)     Click Help on the far right side of the screen
3.)     Click on any hard key or soft key to see the SCPI commands for that function

Regards -
Like • Show 0 Likes0
Actions
mdewar Nov 7, 2011 10:34 AM
Mark Correct
Correct Answer
Hi,
I have the web-interface open, but do not see the help screen, just the UI. Hovering over the softkeys (Dual ARB) just says softkey<#>.
Like • Show 0 Likes0
Actions
mdewar Nov 7, 2011 11:39 AM
Mark Correct
Correct Answer
I found the button. It is on the GUI for the sig gen itself. I was looking for a help button outside of this.

Thanks for your help.
-m
Like • Show 0 Likes0
Actions

see SCPI sent via the web interface

Outcomes

Related Content

Recommended Content