Skip navigation

Log in to create and rate content, and to follow, bookmark, and share content with other members.

AnsweredAssumed Answered

Why this error popup "error registering COM+ applicatio

Question asked by Hidayah on Feb 15, 2008
Latest reply on Feb 21, 2008 by Dr_joel

Like • Show 0 Likes0
Comment • 1

Hi,

When I run the Agilent PNA support insaller, why there will an error said that "error registering COM+ application" ?

Regards,
Dayah

No one else has this question

Outcomes

1 Reply

Dr_joel Feb 21, 2008 10:43 PM
Mark Correct
Correct Answer
I think I may have seen this too. What is your firmware Rev?

And what exactly are you installing, and where did you get it from. I'll stop by Jval"s desk and see if he has a good answer to post (before I take all his money tonight... )
Like • Show 0 Likes0
Actions

Recommended Content