AnsweredAssumed Answered

DSO-X 3034A - How to disable the help-screen?

Question asked by foobar on Nov 21, 2012
Latest reply on Nov 22, 2012 by bret

Like • Show 0 Likes0
Comment • 4

Hi.
How can i disable the help-screen which shows automatically after the bootup-procedure?
(The one with the two big arrows and the 30day-trial button)

Thanks.

No one else has this question

Outcomes

4 Replies

Coris Nov 21, 2012 8:58 AM
Mark Correct
Correct Answer
You can not disable this annoying/stupid start screen... I`ve claim quite long time ago about the same, but it seems Agilent do not want (or care) to remove it...
Do you know what one should try for 30 days?

Edited by: Coris on Nov 21, 2012 9:58 AM
Like • Show 0 Likes0
Actions
- bret @ Coris on Nov 22, 2012 5:29 AM
  Mark Correct
  Correct Answer
  I fully understand that everyone have their own preferences and views. My opinion on this is, while annoying and pointless, it's no big deal. It's the same as other software showing their splash screen -- I would prefer the software to just load faster rather than spend time showing ****.
  
  Coris, you keep asking about what the 30-day trial does ... why not just click it to find out? It's a trial, which means it will go away in 30 days anyway, so what's the point in holding on to it? Just try it. If it's cool, then buy it.
  
  Also, did you make a formal request to remove the splash screen, or just complain in this forum? I don't believe this forum is the right channel to request for enhancements (*although I hope there will be one specific category for "User Feedback"*). I think the only way to request is to get in touch an Agilent rep directly.
  
  Edited by: bret on Nov 22, 2012 6:29 AM
  Like • Show 0 Likes0
  Actions
  - Coris @ bret on Nov 22, 2012 11:25 AM
    Mark Correct
    Correct Answer
    As I can understand from your writing "tone", my previous post it seems to irritated you. Sorry for that. But nobody force you to read my posts...
    I see that your expressed opinion is against that start screen too. I can hardly understand why it disturb you when I express the same opinion (before you), no matter what it is called (claim, suggestion, feed back, and so on). It may only your opinions/feedbacks matters here? At last, if you get uncomfortable when you reed my posts, just ignore (do not read) it...
    Maybe you should know that one of the important meanings with this forum is a "user feedback" too, directed to Agilent.
    When about the 30 days trial button, as a user of an Agilent device, I think I have a minimum right to know what trial software is installed in the same time with the upgraded firmware. Else I known quite well to click on buttons, if you wondered about that... and I knows too, what the trial software is...
    I may say that I experience your tone in this post (answering my previous one) on the border of an inappropriate...
    Like • Show 0 Likes0
    Actions
    - bret @ Coris on Nov 22, 2012 7:06 PM
      Mark Correct
      Correct Answer
      Hey Coris,
      
      Sorry that I gave you impression that I was irritated with your post. Maybe I used the wrong choice of words. Just voicing out opinions (and was meant to be in neutral tone :D), just as you are.
      
      Bret.
      Like • Show 0 Likes0
      Actions

DSO-X 3034A - How to disable the help-screen?

Outcomes

Related Content

Recommended Content