AnsweredAssumed Answered

Command E3644A to meter mode via remote GPIB interface

Question asked by wassaw on Apr 6, 2011
Latest reply on Apr 22, 2014 by MattC
We wish for our application to display periodic current output on the power supply's front panel, along with the constant voltage output, w/o the PC sending periodic "MEAS:CURR?" commands to the power supply.  Is it possible to send a command to the power supply (across the GPIB interface) to set the power supply's front panel display to meter mode?

One thought/attempt was to send a "SYST:LOC" command to the power supply, but this command is only supported for the RS-232 interface.

Many thanks in advance!