Does anyone know if it's possible to display node voltages for a lumped element rf filter? I have given the nodes names but don't know how to display the voltages at those nodes over frequency. I have a 2-port circuit with s-parameter input component. There is a setting in the termination instances for Vdc which I assume sets the max input voltage (?).

Any help would be appreciated.

Thanks.

Any help would be appreciated.

Thanks.

In adition it is typical when doing this this style of DC simulation you would use a DC source, like a V_DC, to bias the circuit. Using the Term would still work but the voltage source is in series with the Internal Reference Impedance of the component so for a 50 Ohms nominal input impedance only half the voltage would be applied to the circuit under test and half would be disipated in the Term.